Honda Power Products HHB25 Manuel De L'utilisateur page 62

1. Set the hot air duct on the engine top cover by aligning the groove
and locking tabs with the ribs of the engine cover as shown.
2. Tighten the 3.5 x 8 mm self-tapping screw securely.
HOT AIR DUCT
3. Remove the air cleaner cover (see page 24).
4. Install the hot air joint to the air cleaner case as shown.
Check that the locking tabs of the hot air joint lock against the ribs of
the air cleaner case securely.
AIR CLEANER CASE
RIB
HOT AIR JOINT
ENGINE COVER
GROOVE
3.5 x 8 mm
SALF-TAPPING SCREW
SECOND HOLE
FROM LEFT END
AIR CLEANER CASE
LOCKING TABS
RIGHTMOST HOLE
59