Start Up - American Hometec Changing the Game AHQ-B03X Guide D'utilisation Et D'installation

3. Install the inlet water filter (D) in the cold water inlet. Install the filter such that it
is easily removable for inspection and cleaning.
4. Test water connections for leaks. Turn on water and purge water through the
water heater and system. Flow for 1

Start Up

Open water inlet and outlet. Turn on water and let water flow through unit for one to
two minutes and double check to ensure there are no leaks. CAUTION: DO NOT
OPERATE UNIT DRY.
1. If no leaks are found, turn on the power to unit at breaker.
3. Turn on the water heater power switch located on the control panel on
the front of the unit.
FOR REFERENCE: Temperature for bathroom sink is typically set to 98
kitchen is typically set to 110
However, temperature should not exceed 125
scalding.
4. Adjust water flow to a normal setting.
5. Set temperature to display Celsius or Farenheit.
-
2 minutes. Ensure all air is eliminated.
F / 43 C. Adjust temperature to
o o
10
F / 37
o
meet your comfort needs.
F / 52 C due to possibility of
o o
C and for
o