Connect Water - American Hometec Changing the Game AHQ-B03X Guide D'utilisation Et D'installation

5. Turn power on. Set power capacity by holding down the On/Off button for
5 seconds to switch between 3.4KW and 2.4KW. If 3 lights blinking for 3
times, it is set to 2.4kw. If 4 lights blinking for 3 times, it is set to 3.4kw.
Once set turn off power once more.
CAUTION: Do not switch on power. This will be done during start up steps.

Connect Water

1. Notes
Arrows on the unit near the connections indicate cold water inlet (
water outlet (
Use a PTFE based pipe sealant or tape to ensure leak free connections.
Do not sweat fittings or weld pipe to unit.
Isolation valves are recommended.
Hard connections or flexible braided tubing connections are both acceptable.
However, flexible braided tubing is preferred.
CAUTION: DO NOT OVERTIGHTEN, MAY BREAK THE PIPE CONNECTION AT HEATING
ELEMENT.
2. This unit does not require a pressure relief valve. However if local codes require,
install the supplied pressure relief valve (C)
Cable Aperture
Cable Clamp
↓
).
Figure 5: Internal Diagram & Plugs
N
120 volt 20 amp
12AWG
HBL5366C
120 volt 30 amp
N
10AWG
.
9
G
N
L
L
HBL2311
N
G
L
L
HBL9309
HBL2611
↑
) and hot
G
G