Mounting - American Hometec Changing the Game AHQ-B03X Guide D'utilisation Et D'installation

Mounting

1. Choose location
1) Orientation: Only install unit vertically with inlet and outlet connections
on the bottom. DO NOT install horizontally or upside down.
2) Install indoors. Product not designed for outdoor installation.
3) Caution: DO NOT INSTALL IN A BATH ENCLOSURE OR SHOWER STALL.
For Canada Only (required standard language that does not apply to this
Coilless Technology® tankless water heater): DO NOT CONNECT TO A SALT
REGENERATED WATER SOFTENER OR A WATER SUPPLY OF SALT WATER
4) Do not install the water heater in cold location, below the freezing point of
water (32
5) Clearance required: 2" above, 5" below, 1" to each side.
2. Prepair for Mounting the Unit
1) Use the mounting template and a pencil to mark the location of the
holes. The template will ensure clearance requirements are maintained.
2) Attach the wall mounting bracket (B) to wall using the screws provided.
3) Lift the water heater and slide the tab of the mounting bracket on the back
of the water heater (A) over and into the opening on the wall mounting
bracket (B) as shown in Figure 3. Do not Mount the unit at this time simply
check for clearances and measurements of electrical cables and piping.
4) The actual Mounting of the unit will take place during the Connect
Electrical section to follow.
5) Note: Only licensed professionals should open the cover panel of unit.
F / 0 C).
o o
6
-