Start Up
1. Open water inlet and outlet. Turn on water and let water flow through
unit for one to two minutes and double check to ensure there are no
leaks. CAUTION: DO NOT OPERATE UNIT DRY.
2. If no leaks are found, turn on the power to unit at breaker.
3. Turn on the water heater power switch located on the control panel on
the front of the unit.
FOR REFERENCE: Temperature for bathroom sink is typically set to 98
typically set to 110
F / 43
O
temperature should not exceed 125
4. Adjust water flow to a normal setting.
5.
Menue navigation/Set temperature to display Celsius or Farenheit.
C. Adjust temperature to
o
F / 52
o
AHQ-T16
LED display shows actual outlet water temperature
LED lights shows ℃ or ℉ (Factory Default Temp set to 110℉)
LED display shows shower
LED display shows water heating procedure
UP and DOWN buttons for adjusting water temperature. 1℃
(2℉) up or down each time. 5℃ (10℉) up or down when
holding 5 seconds. Temp range is 35℃(95℉) to 52℃(125℉)
POWER button for turning heater on or off. When heater is powered
on, unit is on standby until there is a hot water demand. Unit will
heat water whenever hot water faucet is turned on and incoming
water temperature is lower than temperature set. If the heater will
not be in use for a long time (such as during vacation), this POWER
button is recommended to be turned off. Holding the button 5
seconds and more can switching between ℃/℉ display.
10
F / 37
o
meet your comfort needs. However,
C due to possibility of scalding.
o
C and for kitchen is
o