Bosch TracRac T3B Consignes De Fonctionnement/Sécurité page 4

Station de travail
Masquer les pouces Voir aussi pour TracRac T3B:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To adjust the tension of the bolt, keep handle in the
down position, back nut off, adjust bolt tension and
re-tighten nut.
BAG
2
Loosely assemble round head bolt, bolt pad,
handle and hex nut as shown.
Attach Support Arms
Slide support arm pads, along with round
head bolt and bolt pad, into side T-slot. This
can be done from either side.
1
Adjust Tool Mount Handle
With handle pointing down, lightly turn bolt,
counter-clockwise, with screwdriver until snug
(be careful not to over tighten). Continue to
hold handle in the downward position, keep-
ing bolt from rotating with screwdriver, and
tighten nut clockwise with 1/2'' wrench.
Repeat assembly with second support arm.
Arm should slide freely with handle in the
unlock position, but be rigid when handle is
tightened.
2
Insert end cap onto main beam end. Use a
3/8" open-end wrench to install and tighten
two #14 self tapping screws. Do not over
tighten. Repeat with second end cap.
Note: These end caps also serve as support
arm safety stops.
4
SUPPORT ARM
Install End Caps
3

Publicité

Table des Matières
loading

Table des Matières