Frigidaire FAFW3801LW Tout À Propos De Installation page 10

InStallatIon InStructIonS
Connecting drain and electrical
1 Snap one end of the drain hose hanger (shipped
in washer drum) onto the drain hose. Continue
wrapping it around the hanger and snap it in place.
2 Place the hook end of the drain hose in the drain
opening. Secure the drain hose with the cable
tie (provided in the enclosure package) to the
standpipe, inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the water.
Important
Check to ensure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
3 Plug the power cord into a grounded outlet.
Grounding type
wall receptacle
Power cord with
3-prong grounded plug
4 Turn on the power at a circuit breaker/fuse box.
5 Carefully slide the washer to its final position.
Recheck for level and rock corners for stability.
Remove and discard door tape.
6 Read the Use & Care Guide provided with the
washer. It contains valuable and helpful information
that will save you time and money.
7 If you have any questions during initial operation,
please review the "Service Prevention Checklist" in
your Use & Care Guide before calling for service.
8 Place these instructions in a location near the
washer for future reference.

note
A wiring diagram and technical data sheet are located
under the washer top panel, on top of the detergent
dispenser housing.
10
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
caBle tIe