Pool Maintenance - Coleman Power Steel Notice D'utilisation

Filling Pool with Water
ATTENTION:
Do not leave pool unattended while filling with water.
1. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the pool to collapse.
In times of heavy rainfall you may need to empty some of the water to ensure the level is correct. (See Fig. 7)
2. When filling the pool is completed, check that the water is not collecting on any side to ensure the pool is level.
IMPORTANT:
If pool is not level, drain water and re-level ground by digging out (See Fig. 8).
Never attempt to move the pool with water in it, serious personal injury or damage to the pool may result.
WARNING:
Your pool may contain a great deal of pressure. If your pool has any bulge or
uneven side then the pool is not level, the sides may burst and the water may discharge suddenly causing
serious personal injury and/or damage to property.
3. Check pool for any leaks at valves or seams, check ground cloth for any evident water loss. Do not add
chemicals until this has been done.
NOTE:
In the event of a leak, patch your pool using the
Refer to the FAQ's for further information.
Fig.7
70%
30%
Fig. 8

Pool Maintenance

If you do not adhere to the maintenance guidelines below, your health might be at risk, especially
that of your children.
IMPORTANT:
If you don't respect the ideal values of the water chemicals the PVC
can be damaged and become discolor.
The following table lists the sequence of the tests that should be carried out for the ideal values
and possible actions. Regularly check the pH value and chlorine concentration weekly and adjust
to the ideal values.
TEST
pH value
Cyanuric acid
Free chlorine
Chlorine compound
Algae
Calcium hardness
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of chemicals and pH kits.One of
the most important factors to increase the life of the liner is to keep continously clean and
healthy water. Please strictly follow the instructions from professional technicians for the water
treatment through the use of chemicals.
2. Locate a bucket of water next to pool to clean users' feet before entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean cloth.
7. Please be careful in case of rain water, kindly check that the water level is not higher than the
expected. If so, YOU HAVE TO DISCHARGE THE EXCESS WATER
Proper maintenance can maximize the life of your pool.
During the season of use of the swimming pool, the filtration system must be necessarily put into
service every day, enough time to assure at least a complete renewal of the volume of water.
ATTENTION:
Do not use pump when pool is in use.
During the season of use of the swimming pool, the filtration system must be necessarily put into
service every day, enough for a long time to assure at least a complete renewal of the volume of water.
Repair
Check pool for any leaks from valves or seams, check the ground cloth for any evident water
loss. Do not add chemicals until this has been done.
NOTE:
In the event of a leak, patch your pool using the underwater adhesive
repair patch provided. Refer to the FAQs for further information.
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose in the area where you are
going to drain your pool. (Check local regulations for drainage by-laws).
3. Screw the control ring of the hose adaptor clockwise onto the drain valve. The drain valve will
be open and water will start to drain automatically.
ATTENTION:
Water flow can be controlled with the control ring.
4. When draining is finished, unscrew the control ring to close the valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Do not leave the drained pool outside.
underwater adhesive repair patch
90%
0°
IDEAL VALUES
7.4– 7.6
30 – 50 ppm
2 – 4 ppm
0
None visible
200 – 400 ppm
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together,
fold pool carefully. If pool is not completely dry, mold may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF
and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as per above instructions also.
5. Improper draining of the pool might cause serious personal injury and/or damage to personal
property.
6. We strongly recommend the pool is disassembled during the off season (winter months). Store
in a dry location out of children's reach.
provided.
6
P-S-004792