Publicité
Les langues disponibles
Les langues disponibles
5. FINAL TUNING
• After the Course Speed Test, your zipline cable may "stretch" slightly (this is normal) and require some additional
tightening by loosening your U-Clamps, pulling the slack out (Remember to have your 2 helpers with brooms lift
and support the cable and trolley while you are pulling out the slack) and then re-tightening the U-Clamps
• Check the tightness of all nuts and bots of all clamps and the trolley.
• Always walk the area and remove any rocks, debris, or other objects that might cause harm to the rider. NEVER
assume that the course is clear, check it before each use.
• If you have extra cable at the end of your setup you must either coil up carefully the extra cable and clamp and
place a piece of tape on the cut end to prevent possible injury.
• Check the rope knot on the bottom of the seat and make sure the knot will NOT pull through the seat.
• Check the trolley grips and make sure they do not slip or twist.
• ALWAYS MAKE SURE YOUR RIDERS KNOW AND FOLLOW THE RULES AND INSTRUCTIONS!
PLEASE DO NOT RETURN YOUR RIPLINE PRODUCT TO THE STORE!
WE ARE HERE TO HELP YOU!
IF YOU HAVE ANY QUESTIONS ABOUT YOUR ZIPLINE
PLEASE CONTACT US:
1-844-834-4334 • INFO@RIP-LINE.COM
b4 Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
Info@Rip-Line.com · www.b4adventure.com - DC:080818
8
Publicité
