Publicité
Les langues disponibles
Les langues disponibles
3. ATTACHING YOUR ZIPLINE
The installation should only be performed by an adult and in accordance with these instructions. Your course cable
comes with protective tubing for the bark of your tree.
• STEP 1: Take the main cable and wrap the looped end around your Start Point tree (Figure 1) and thread the
un-looped end and the rest of the cable through the looped eye and set at a height from the guideline on page 3.
• Install Tip Option: Determine your Start Point and Finish Point heights. Use three of the six small nails (spaced 2 In.
apart) for each tree to keep the cable from slipping down the tree during installation.
Note: Do not put the nails into or through the cable.
• Thread the cable, using the blunt, un-looped end through the trolley (Figure 2) between the two pulleys and the grip
bar. Now wrap the un-looped end around your Finish Point tree at the initial finish point height of 78 In. and rest the
cable on the three small nails - see tip above.
Three small
supporting
nails
STEP 2: U-Clamp installation - Have your helping friends use their brooms to lift and support the trolley and cable
while you perform the installation. This will help you pull out the slack and attach your U-Clamps.
when you wrap your zipline around the Finish Point tree, you want to form a "tear drop" shape wrapped around the
tree - see Figure 3 on next page. DO NOT TIGHTEN UP AGAINST THE TREE!
• With two helpers supporting the trolley and cable, pull the wrapped cable as tight as you can with your hands. While
holding tight with one hand attach the first U-Clamp and tighten slightly (2 Ft. from tree)
• Repeat the above until you removed as much slack by hand as possible. Then tighten the first U-Clamp to 30 Lbs of
torque, or as snug as you can with hand tools. DO NOT OVER-TIGHTEN.
• Tidy up your excess cable by simply coiling it up and securing and covering the coil with duct tape.
b4 Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
Starting Point
See instructions for proper mounting heights. Do not suspend cable
over any hard surface. Stable mounting platform required for safe and
proper use. Tools needed: Pliers & wrench.
WARNING! CHOKING HAZARD
This product contains small parts. Do not
allow children under 3 years of age near the
parts or assembly area.
Info@Rip-Line.com · www.b4adventure.com - DC:080818
Trolley
Finish Point
Clamps
Three small
supporting
nails
5
Publicité
