Publicité
Les langues disponibles
Les langues disponibles
A - Stress Load Test:
Test your installation at 5 Ft. (152 Cm) from each end of the cable, one of 2 ways
• Suspend 250 Lbs (113 Kg) from the rope attached to the trolley
OR
• Throw a rope over the cable and have a 250 Lbs (113 Kg) person lift their weight off the ground.
Note: Look and listen for any issues. This will ensure that the attachment structure and cabling is stable and
secure.
DO NOT EXCEED 250 LBS (113 KG) FOR THE TEST.
B - Course Speed Test:
• The test weight should never hit the finish point U-Clamps!
• With the 250 Lbs (113 Kg) weight attached to the trolley, launch the trolley down the course. The test weight
should slow down past the midpoint as the sag or dip in the cable comes into play. It should continue to slow down
and come to a gentle stop just short of the first U-Clamp. If the test weight hits the U-Clamp, adjust the cable
tension (loosen the U-Clamp and pull tighter), or if more speed reduction is required, adjust attachment heights:
raise Finish Point or lower Start Point. BE SAFE, NOT FAST!
• REPEAT TEST 5 TIMES! This test helps stretch out the cable.
Note: Weight should not drag on the ground at any point during the test.
b4 Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
Test at 5 Ft. from each end by
attaching 250 Lbs (113 Kg) OR
hanging with a rope as illustrated
5 Ft.
TEST FREQUENTLY!
Start Point
Push weight to
Start Point and
release. Be Careful
to stay out of the way
Info@Rip-Line.com · www.b4adventure.com - DC:080818
5 Ft.
Finish Point
7
Publicité
