Mounting And Operation; Initial Operation - Bosch GlassVAC Notice Originale

10 | English

Mounting and Operation

Action
Product features
Delivery scope
Charging the battery pack
Connect/disconnect the cleaning head D
Filling the spray applicator
Connecting the spray applicator head
Attaching the microfiber cloth 110 mm F
Connect the applicator head 276 mm
Attaching the microfiber cloth 276 mm
Disconnect spray applicator head
Using
Empty the dirty water tank
Cleaning the machine
Detach the microfiber cloth 110 mm
Cleaning microfiber cloth
Accessories

Initial Operation

Observe the mains voltage! The voltage of the power
source must correspond with the data on the type plate of
the battery charger.
Troubleshooting
Problem
Machine will not switch on
Restricted or no vacuum
Machine turns itself off
Water leaks from machine
Battery will not charge
Streaking on windows
Maintenance and Cleaning
(see figure J – K)
Always clean the product thoroughly after use.
Remove the cleaning head from the main body and rinse.
Whilst cleaning head 2 is removed from the machine, fill the
dirty water tank 7 via the cleaning head aperture to the max
line with clean, warm water. DO NOT fill the dirty water tank 7
F 016 L81 778 | (31.1.18)
Figure Page
A 147
B 148
C 149
149
E 150
150
G 151
H–I 152–154
I 154
J–K 154–155
L 156
M 156
Possible Cause
Battery discharged
Battery too hot/cold
Cleaning head blocked
Drain plug remove
Battery too hot/cold
Cleaning head blocked
Spray applicator not mounted correctly
Charger not connected correctly
Battery too hot/cold
Wiper blade damaged
Too much force applied
Too little force applied
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery using
the charger before using your machine for the first time.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The battery is protected against deep discharging.
When the battery is discharged, the machine will stop.
Battery Charging (see figures A and C)
Note: The micro-USB port 20 for connection of the micro-
USB cable 17 is in the handle.
When the battery charge is low, the charger level indicator 4
flashes green.
When the charger level indicator 4 flashes red the battery
must be charged. Turn machine off and charge the battery.
Connect the machine to the charger 18 using the micro USB
cable 17 provided. Plug the charger 18 into the socket. The
charging process begins.
During the charging procedure, the handle of the machine
warms up. This is normal.
The charger level indicator 4 continuously lights up red during
the charging procedure. When the battery is fully charged, the
charger level indicator 4 continuously lights up green.
Disconnect the charger from the mains supply when charging
process ends.
Observe the notes for disposal.
Corrective Action
Recharge battery
Allow to cool/warm
Unblock cleaning head
Replace drain plug
Allow to cool/warm
Unblock cleaning head
Mount the spray applicator correctly
Check charger and USB cable connections
Allow to cool/warm
Replace wiper blade (accessory)
Apply reduced force
Apply more force
via the drain hole. Shake the machine and pour the water out
via the drain plug 8.
Maintenance of the cleaning head
Protect the cleaning heads against damage during storage.
Prevent the wiper blade from touching paper or cardboard, as
this could damage the wiper blades polymer coating.
Spots or lines may be visible on the polymer coating. This is
normal and does not affect the cleaning performance.
Bosch Power Tools