GRAUPNER GF-16 Instructions De Montage page 25

Control surface travels:
The transmitter must first be set to Delta (or V-tail) mode.
Aileron travel relative to centre
elevator travel relative to centre
Centre of gravity : 570 mm mesured from tip of the fuselage
First flight:
- Assemble the model as described in these instructions, program the radio control
system as explained above, and charge all the batteries fully. There is now no excuse
for not flying the model!
- We recommend that you carry out a range check with the motor running before you fly
your new aeroplane.
- Do not attempt to fly this model unless you are a pilot with considerable flying
skill and experience.
- Although the aeroplane is extremely simple to build, it is demanding to fly.
We have flown the GF-16 in all conditions equipped with the recommended
components, and have encountered no technical problems.
Used batteries, servos and controllers may not be given in domestic waste. Defective or
faulty batteries should be released at collecting points for hazardous waste or should be
handed over to the shop, where you bought them.
All of us in the Graupner Team hope you thoroughly enjoy building and flying your GF-
16.
Yours - the Graupner team
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
± 15 mm 15% Expo
± 20 mm 35% Expo
25
09/2008