Electrical Diagrams - Franklin Electric INLINE Serie Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

5. If mounting in wet environments, liquid-tight cables (Figure 6)

or flexible conduit fitting (Figure 7) are required (not supplied) to

ensure that the enclosure maintains a watertight Type 4 rating.

Install the liquid-tight cables or flexible conduit fitting into the

conduit nuts in front of the power supply and motor connectors

(Figures 6 and 7, page 8).

WARNING

conduit and fittings must be used to maintain Type 4 rating

(Figures 6 and 7). If you use water-resistant cables to run

electrical wire to the pump (Figure 6), tighten the supplied

cable/conduit connector to torque of 106 in-lbs (13 Nm).

If you use flexible conduit fittings to run electrical wire to the

pump (Figure 7), tighten the supplied cable/conduit connector

to a torque of 106 in-lbs (13 Nm), compressing the O-ring against

the outside housing of the flow control.

NOTICE

Install the cable/conduit connector with

the arrow pointing towards the flow control, as shown

in the figures.

6. Route supply wires through the flexible conduit fitting into the

wiring chamber of the flow control.

Connect the supply ground wires to the ground lug in the

wiring compartment.

NOTICE

The safety earth ground connection

is marked at its terminal using the

8. Connect the supply wires to the screw terminal marked

L and N (Figure 5). Use only copper wires rated for at

least 60 °C. Lead wire terminals should be tightened

to a torque of 4 in-lbs (0.5 Nm).

9. Connect the motor wires to the screw terminal marked

U and V (Figure 5). Use only copper wires rated for at

least 60 °C. Lead wire terminals should be tightened

to a torque of 4 in-lbs (0.5 Nm).

10. Replace the cover and tighten the screws. For proper sealing,

the screws should be tightened to a torque of 13 in-lbs (1.5 Nm).

11. Once the cover has been replaced, ensure that the pump has

been correctly primed and reconnect the main breaker.

Liquid-tight cables or flexible

symbol (Figure 5).

Voltage Rating Table

On the product label, verify the voltage rating for the device and do

not exceed that voltage rating.

Supply Voltage

Motor Voltage

Single-phase 115 V

Single-phase 230 V Single-phase 230 V