Abus NVR10040 Mode D'emploi page 40

4
Set the adapter speed tye ‚NIC type'
manually. Default and recommended
setting is the automatic detection
(Self adaptive).
40
5
If you wish the address data to be
automatically assigned, tick the
"Enable DHCP" checkbox.
The addresses will then be
automatically assigned by your
router (where supported).
If proceeding in this way,
move on to point 13.
6
192.168.0.20 192.168.0.25
192.168.0.1
If your router does not automatically
assign the address data, enter the
data according to the following steps.
The image gives an example of
connected devices with the
corresponding IP addresses.
English