Apex iCH Auto Instructions D'utilisation page 10

iCH Auto/English
3.3 Setting Up
1. Place the device on a flat surface and at a lower level than your sleeping position.
2. Connect one end of the air tubing firmly to the air outlet on the back of the device, as shown in
Figure 3-5.
3. Connect the other end of the air tubing to the mask system. Put on the mask and headgear
according to the mask instruction manual.
4. Plug the socket end of the AC power cord into the power supply adapter. Plug the pronged end of
the AC power cord into a main electrical outlet.
5. Plug the power supply cord's adapter connector into the power inlet on the right side of the
device, as shown in Figure 3-6.
6. Once the power supply cord's adapter connector is plugged into the power inlet, the CPAP
system is in ready to operate position ("STANDBY" sign appears in LCD display)
NOTE: The AC power cord also serves to disconnect the device.
NOTE: Do not position the equipment so that it is difficult to operate the disconnecting
device.
Figure 3-5 Figure 3-6
7