Technical Specifications; Maintenance And Storage - KRATOS SAFETY FA 20 702 Serie Mode D'emploi

TECHNICAL SPECIFICATIONS:

THE FALL ARRESTER MUST BE USED ON THE SPECIFIC ANCHORAGE LINE ON WHICH IT WAS CERTIFIED.
The mass of the user, including tools and equipment, shall neither exceed the maximum rated load (100 kg), nor be less than the minimum rated load
(40 kg).
COMPATIBILITY FOR USE:
The device can be used with a fall arrest system as defined in the product's factsheet (see standard EN363) to guarantee that the dynamic forces exerted
on the user during the arrest of a fall is maxi 6 kN. A fall arrester harness (EN361) is the only body support device permitted for use. It may be dangerous
to create your own fall arrest system in which each safety function may interfere with another safety function. As such, before each use, refer to the
recommendations for use for each of the system's components.
INSPECTIONS:
The recommended service life of the equipment is 10 years (in accordance with the annual examination by a competent person authorized by KRATOS
SAFETY), but it may be increased or reduced according to use and/or the results of the annual inspections. The equipment must be inspected regularly
in case of doubt, fall and at least every twelve months by the manufacturer or a competent person appointed by it, to ensure its resistance and the safety
of the user.
The product data sheet should be completed (by writing) after each verification, date of inspection and date of next inspection must be indicated on the
data sheet, it is also recommended to put date of next inspection on the product.
MAINTENANCE AND STORAGE: (these instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and in its packaging. Clean with water, wipe with a cloth and hang in a ventilated
room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may have got wet during use.
The device must be stored in a cool, dry and ventilated room, and in its packaging.
Slide
Stainless steel and brass
See the installation guide for anchorage line KS8000 and KS9000.
Anchor rail Use on a sloped plane
Aluminium
6