Beem Classico 03428 Mode D'emploi page 145

EN
Problem
The red indicator light
lights up constantly.
The yellow indicator
light (22) fl ashes.
The espresso runs
very slowly into the
cup.
The espresso is too
weak.
A large amount of
steam is produced in
the brewing process.
03428_DE-EN-FR-NL_A5_V3.indb 40 03428_DE-EN-FR-NL_A5_V3.indb 40
Possible cause
The device is defective.
The device is furred up.
The coffee outlet (14) or the
fi lter is clogged.
The device is furred up.
There is not enough coffee
powder in the fi lter.
The set espresso quantity is
too much for the quantity of
coffee powder in the fi lter.
The device is furred up.
Cappuccino, latte macchiato
or milk froth has been
selected, but there is no milk
in the milk tank.
Fix
Contact the customer service
department via our website:
www.beem.de
Descale the device (see the
"Cleaning and Care" chapter |
"Descaling").
Clean the portafi lter (12) and
the fi lter.
Descale the device (see the
"Cleaning and Care" chapter |
"Descaling").
Pour the right quantity of
coffee powder into the
respective fi lter (see the
"Handling and Operation"
chapter | "Filling the Filter With
Coffee Powder").
The perfect amount of
espresso to suit your own
taste can be programmed in
the device (see the "Handling
and Operation" chapter |
"Programming Quantities").
Descale the device (see the
"Cleaning and Care" chapter |
"Descaling").
Wait until the programme has
run through. Allow the device
to cool down a little. Remove
the milk tank from the device
and fi ll it (see the "Handling
and Operation" chapter |
"Filling the Milk Tank").
Then run the programme
again.
40
12.01.2018 11:24:46 12.01.2018 11:24:46