Reset To Factory Settings - Beem Classico 03428 Mode D'emploi

33
5. The device starts to prepare espresso or make milk froth.
6. Only let go of the button once the quantity of milk or espresso that you want has
passed through. You will hear three beeps. This quantity is now saved under the
corresponding function.
Cappuccino and Latte Macchiato
This process must be carried out twice for latte macchiato and cappuccino: Once
for the quantity of espresso and once for the quantity of milk:
1. On the fi rst operation, set the quantity of milk you want in the manner described in
the previous section. Make sure that the milk nozzle (8) is folded out and there is a
cup below the milk nozzle.
2. Start a second operation by pressing the appropriate button again. A beep sounds.
3. Wait until the quantity of milk has passed through.
4. As soon as the device starts to make espresso, press the appropriate button again
and hold it down. Another beep sounds.
5. Only let go of the button again once the quantity of espresso that you want has
passed through. You will hear three beeps.
Now both the quantity of milk and the quantity of espresso are saved under the
appropriate function.
Setting the Milk Froth Quantity
On the milk tank cover (6) there is a dial (5) which can be used to set whether more milk
froth or more hot milk should be added to the speciality coffee.
For more milk froth: Turn the dial to the top right.
For more hot milk: Turn the dial to the bottom left.

Reset to Factory Settings

If the amount of espresso and amount of milk are to be reset to the amounts preset in
the factory, proceed as follows:
1. Switch off the device via the button
2. Press the buttons
3. Switch the device back on via the
and 5 beeps are heard.
4. Let go of the buttons
settings.
03428_DE-EN-FR-NL_A5_V3.indb 33 03428_DE-EN-FR-NL_A5_V3.indb 33
(16).
(24) and (17) simultaneously and keep them held down.
button. The control panel (X) fl ashes 5 times
and . The amounts have now been reset to the factory
EN
12.01.2018 11:24:44 12.01.2018 11:24:44