Storing Food; Manual Defrost; Operation - Omcan RS-CN-0004-P Instructions

Operation

STORING FOOD

To get the best results from your appliance, follow these instructions: Only store foodstuffs in the appliance
when it has reached the correct operating temperature. Ensure GN container bays are full at all times, even if
the GN containers are unused or empty. Empty bays will greatly reduce efficiency of the appliance.
TURN ON
1. Ensure the power switch is set to [O] and turn on at the socket.
2. Switch on the Power [I]. The current temperature within the appliance is displayed.
3. The on the control panel flash for 3 min for anti-short cycle delay between the motor compressor stop and
the following restart.
TEMPERATURE SETTING AND CONTROL
1. Defrosting light.
2. Compressor operation light.
3. Digital thermostat.
4. Programming key (service agent only).
5. Temperature modification keys.
How to see the set point
1. Push and immediately release the SET key, the set point will be showed.
2. Push and immediately release the SET key or wait about 5s to return to normal visualization.
How to change the set point
1. Push the SET key for more than 2 seconds to change the set point value.
2. The value of the set point will be displayed and the "°C" starts blinking.
3. To change the set value push the UP or DOWN arrows within 10s.
4. To memories the new set point value push the SET key again or waits 10s.

MANUAL DEFROST

The appliance will automatically run a defrost cycle every 12 hours.
9