Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
If the unit is not charging: Make sure the power cable is properly connected to the power
input and the power outlet.
If the sound is distorted: Try lowering the volume control of your sound source.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If you cannot connect your audio device to Party Splash
•
Have your audio device (e.g., smartphone or tablet) and Party Splash
as possible while trying to connect. Make sure both the audio device and Party Splash
are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Party Splash
other audio device and restart the search process. If this does not work right away,
power off Party Splash
more information.
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back
on. You can find this under the Bluetooth menu in the Settings for your phone or other
audio device.
If this does not work, and you have connected to Party Splash
™
Splash
in the list of available or previously connected devices in your audio device's
Bluetooth menu, tap the "gear" or "i" icon located next to it and then select Unpair or
Forget. Turn Party Splash
your available devices list.
Note: If Party Splash
range, you may need to repeat this process with that audio device to fully disconnect.
If you experience audio dropouts while playing music from a Bluetooth device, this may
be happening because your unit is trying to link to another speaker. This can occur if you
power off a speaker that was linked to your unit or if you have just turned on your unit and it is
in Stereo-Link mode. To stop the audio dropouts, exit Stereo-Link mode by double-pressing
the Bluetooth button. Alternatively, you can wait for your unit to link to another speaker if
there is one within range.
If there is a delay in the audio signal between the left and right speakers when linked,
break the link by double-pressing the Link button, and pair them again following the
instructions in the
Linking Two Speakers
8
™
and then power it back on. See
™
off and back on and try pairing again once it reappears in
™
has been paired to another audio device recently that is still within
section.
™
via Bluetooth:
™
to disconnect Party Splash
Pairing a Bluetooth Device
™
as close together
™
from any
for
™
before, find Party
™
Publicité
Table des Matières
