Publicité
Les langues disponibles
Les langues disponibles
User Manual
Introduction
Thank you for purchasing the Fibre Optic HDMI 2.0 Extender. This fibre optic extender allows you to
transmit HDMI 2.0 UHD signals with the full resolution of at least 3840 x 2160 @ 60Hz, with HDCP without
compression or loss of quality up to 200m/600feet using a single MPO Fibre cable.
Features & Specifications
▪
Extends HDMI 2.0 signals over MPO Fibre Cable (12 core, 50/125µm)
▪
Auto Laser disable if fibre cable is broken or removed
▪
Compatible with HDMI 2.0 specification, supports digital audio, transparent
▪
Supports resolutions at least up to 4K 60Hz (3840 x 2160p @ 60Hz), transparent
▪
Supports HDCP (acts as cable: no decoding/encoding, transparent)
▪
Maximum HDMI cable length up to 2m in and out
Package Contents
▪
LINDY Fibre Optic HDMI 2.0 Extender (1x Transmitter, 1x Receiver)
▪
2x Multi-Country wall mount power supply 100 - 240VAC / 5V DC
▪
This User Manual
Installation and Operation
Important! Do not bend the MPO fibre cable beyond its maximum bend radius and ensure the
connectors are protected from dust. Please keep the protecting caps.
1. Use HDMI cables (≤ 2m) to connect your HDMI source to the Transmitter and HDMI sink (monitor,
splitter, converter, ...) to the Receiver.
2. Remove the dust covers from the MPO fibre connectors and connect them to the Transmitter and
Receiver. Please ensure that the connectors snap into place before proceeding.
3. Plug the power supplies into the transmitter and receiver and power on all your devices starting from
the sink (monitor).
4. All LEDs on Transmitter and Receiver should be lit.
a. If this is not the case ensure that all connectors are fully engaged!
b. If the power LED is not lit the Transmitter or Receiver isn't powered up or faulty
c. If the Source LED is not lit the HDMI connection to the source is not established correctly
d. If the Sink LED is not lit the HDMI connection to the Sink device is not established correctly
e. If the Fiber LED is not lit the fiber connection between Transmitter and Receiver is not working.
Check if the connectors are seated well and if there is not any dust or dirt in the connection. If this
doesn't help check if the fiber cable is broken or has a kink and replace it.
5. If none of this helps try shorter HDMI cables
6. If also this does not help please contact LINDY Technical Support team under the contact information
provided on our websites.
English
Publicité
