Whirlpool WFG745H0FS Instructions D'installation page 16

To Convert Oven Bake Burner (Natural Gas to LP Gas)
1. Remove the oven racks.
2. Remove 2 screws at the rear of the oven bottom.
3. Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
A
A. Screws
B. Oven bottom
4. Remove 1 screw from the bake burner.
5. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orifice, and set the bake burner aside.
A
A. Screw
B. Bake burner
6. Use a ³⁄₈" nut driver or combination wrench and turn the
Natural gas bake burner orifice spud counterclockwise to
remove. The spud will be stamped with a "47."
7. Replace the "47" spud with a "56" spud. Install the LP gas
bake burner orifice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
16
B
B
A
A. Orifice spud
8. Position the back of the bake burner over the oven orifice,
and slide the tab on front of the bake burner into the front of
the oven.
9. Reattach the bake burner with 1 screw.
10. Position the front of the oven bottom panel toward the front
frame and lower the rear of the oven bottom panel into the
oven.
11. Reattach the oven bottom panel with screws.
To Convert Oven Broil Burner (Natural Gas to LP Gas)
1. Remove the screw from the broil burner.
2. Remove the broil burner from the broil burner orifice hood.
NOTE: The broil burner will hang in the back of the oven while
changing the orifice hood.
B
A. Broil burner
B. Screws
C. Orifice hood
3. Use a ³⁄₈" combination wrench and turn the Natural gas broil
burner orifice hood counterclockwise to remove. The hood
will be stamped with a "155."
4. Replace the "155" hood with a "100" hood. Install the LP gas
broiler burner orifice hood, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
A. Orifice hood
5. Place the broil burner on the broil burner orifice hood and
insert the broil burner ceramic igniter in the hole in the rear of
the oven.
6. Position the broil burner against the top of the oven and
attach it with 2 screws.
7. Replace storage drawer or warming drawer. See the "Storage
Drawer" or "Warming Drawer or Premium Storage Drawer"
section.
8. Replace the oven door if it has been removed. See the "Oven
Door" section.
9. Replace the oven racks.
A
C
A