Rupes SLP41A Notice D'emploi Et D'entretien page 10

op SLP41A- SO210AP_mag2015:SLP41A.qxd
FITTING ABRASIVE PAPER SHEETS
Press the abrasive paper sheet into the plate ensuring that the ho-
les in the paper coincided with extraction holes.
BEFORE STARTING THE TOOL
Ensure that:
- the compressed air feed line and connection are in perfect
working order;
- the start switch (2) is working properly. This must be done with
the air supply switched off;
- all the components of the tool are mounted correctly and do not
show any signs of damage.
STARTING AND STOPPING
- Starting: rotate knob (2) in the direction indicated by the arrow.
- Stopping: release the knob.
TEST RUN
Start the tool and check that there are no unusual vibration.
Otherwise switch-off the tool immediately and eliminate the
cause.
SELECTING THE RPM
The rpm can be adjusted by rotating the knob (3). The choice of
speed depends on the characteristics of the abrasive paper
sheets and the material to be worked.
SUCTION FLOW CONTROL
The suction flow can be adjusted by rotating ring-nut (7).
10
11/05/2015 11.36
REPLACING THE ABRASIVE PAPER SHEETS
- Rip off the used paper;
- press the new velcro backed paper in position, ensuring that the
holes in the paper coincide with the suction holes in the plate.
USABLE DISCS
SLP41A
400 x 70 mm punched velcroed sheets of abrasive paper, Hook IT.
SO210AP
225 x 115 mm punched velcroed sheets of abrasive paper, Hook IT.
MAINTENANCE
All maintenance operations are carried out with the tool
disconnected from the compressed air supply.
At the end of each work session, or when required, remove any
dust from the body of the tool using a jet of compressed air.
Lubricate the machine regularly (every 50 hours of operation)
by inserting 2/3 drops of specific oil (synthetic oil without
silicone, ISO 32) into the compressed air connection, keeping
the device in a vertical position, with the connection facing
upwards. After this operation, connect the machine to the
power supply and set it in motion for a few seconds.Lubricate
the machine as described above before storing it for long
periods of inactivity.All damages deriving from incorrect or
inadequate lubrication are excluded from the warranty.
No other maintenance operations must be undertaken by the
user.
Maintenance and cleaning of the inner parts, must be carried out
only by an authorized customer-service workshop.
Pagina 10