Technical Data; Electrical Safety - BGS technic 3380 Mode D'emploi

TECHNICAL DATA

Voltage:
Current:
Peak current:
Air pressure, max.:
Battery:
Operating temperature:
Size:
Hose length:
Weight:
ATTENTION
Carefully read all safety instructions included in these operating instructions. Follow all safety and
operating instructions. Non-compliance of the safety and operating instructions may lead to electric
shocks, personal injury and property damage. Keep the operating instructions at a safe location for future
reference.

ELECTRICAL SAFETY

WARNING!
When using line-operated tools, the following essential safety precautions should always be observed in
order to reduce the risk of fire, electric shock, personal injury and property damage. Before putting the
device into operation, carefully read through the entire manual and make sure that in event of an
emergency, you can switch the device off.
Always check if the power supply corresponds with the voltage on the rating plate. If a power cable is
damaged, it must be replaced by an electrician in order to avoid any risks. Always use an approved
extension cable that is suitable for the power consumption of this tool. Before use, check the extension
cable for signs of damage, wear and ageing. Replace the extension cable if it is damaged.
Note: the double insulation does not replace the normal safety precautions when operating this tool. The
insulation system serves the additional protection against injury, which is caused by a possible failure of
the electrical insulation in the tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Cordless Air Pump
12V DC
≤ 4.5A (without load)
≤ 8A
10.3 bar (150 PSI)
Lithium-Ion 12V, 2000 mAh
-20˚C to 60˚C (-4˚F to 140˚F)
62 mm x 182 mm x 226 mm
(2.44 x 7.16 x 8.90 inches)
135 mm (5.31 inches)
950 g (incl. rechargeable battery)
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 3380
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed