Auto Update - Samsung HW-K650 Manuel D'utilisation

Masquer les pouces Voir aussi pour HW-K650:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

+ if UPDate was not displayed
1. Turn off the Soundbar, connect the USB storage device that contains update files to the Soundbar's USB port.
2. Disconnect the power cord, reconnect it, and then turn on the Soundbar.
● Insert a USB device containing the firmware update into the USB port on the main unit.
● Updating firmware may not work properly if audio files supported by the Soundbar are stored in the USB
storage device.
● Do not disconnect the power or remove the USB device while updates are being applied. The main unit will
turn off automatically after completing the firmware update.
● After update is completed, the user setup in Soundbar is initialised. We recommend you write down your
settings so that you can easily reset them after the update. note that updating firmware resets the
subwoofer connection too.
If the connection to the subwoofer is not re-established automatically after the update, refer to page 16.
If the software update fails, check that the USB stick is not defective.
● mac oS users should use mS-DoS (fAT) as the USB format.
● Depending on the manufacturer, some USB devices may not be supported.

aUtO UPDate

If the Soundbar is connected to the Internet, it will automatically check for the latest firmware and update when new
firmware becomes available, even if it is turned off.
● The Soundbar is configured to run Auto Update by default.
● To use the Auto Update function, the Soundbar must be connected to the Internet.
● The Wi-fi connection to the Soundbar will be terminated if its power cord is disconnected or the power is
cut off. If the power is cut off, turn on the Soundbar and reconnect it.
31
FUNCTIONS

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hw-k651

Table des Matières