Software Update; Auto Update; Usb Update; Reset - Samsung HW-S800B Manuel

10 SOFTWARE UPDATE

Auto Update

When the Soundbar is connected to the Internet, software updates
automatically occur even when the Soundbar is turned off.
• To use the Auto Update function, the Soundbar must be connected
to the Internet.
The Wi-Fi connection to the Soundbar will be terminated if
the Soundbar's power cord is disconnected or the power is cut
off. If the power is cut off, when the power comes back on or
you reconnect the power cord, turn on the Soundbar, and then
reconnect it to the Internet.

USB Update

Rear of the Soundbar
Micro USB to USB
adapter Cable
(not supplied)
Samsung may offer updates for the Soundbar's system firmware in
the future.
When an update is available, you can update the Soundbar by
connecting the USB drive that contains the update firmware to the
SERVICE port of the Soundbar.
1. Go to (www.samsung.com) → search for the model name from the
customer support menu option.
• For more information about update, refer to Upgrade Guide.
2. Download the upgrade file (USB type).
3. Unzip the file to create a folder with the file name.
4. Store the created folder in a USB and then connect it to the
Soundbar.
5. Turn on the Soundbar. Then the product is updated within
3 minutes.
LED
indicator
• During update, do not turn it off or remove the USB.
• If the yellow LED is on after the software update is completed,
this means that an additional update is in progress. When this
happens, don't turn off the power or remove the USB.
• If update does not proceed, reconnect the Soundbar power cord.
• When the latest version is installed, no update is performed.
• Depending on the USB type, update may not be supported.
SERVICE
SERVICE
HDMI
(ARC)
HDMI
(ARC)
White moves from left to
right and right to left
• If there is no update file available, the indicator blinks red
3 times.
LED
indicator
• If the update file is in the same or lower version than the
existing, the indicator blinks cyan 3 times.
LED
indicator

Reset

With the Soundbar on, press the
at the same time for at least 5 seconds. The LED display changes as
shown below and then the Soundbar is reset.
LED
indicator
CAUTION
• All the settings of the Soundbar are reset. Be sure to perform
this only when a reset is required.
ENG - 30
Red Blinks X3
Cyan Blinks X3
5 Sec
(Volume) buttons on the body
White moves from left to
right and right to left
Cyan Blinks X3
Red Blinks → Off