How To Operate Your Friedrich - Friedrich CP05 Manuel D'installation

How to operate your Friedrich

The controls will look like the following.
Control and Remote Control Operations
1
2
3
4
6
Temp
Fan Speed
Timer
4
Money
Saver
2
How to Insert Batteries
1.
Remove the cover from the back of the remote
control.
2.
Insert two batteries.
• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.
3.
Re-attach the cover.
1
2
3
4
5
Power
5
5
1
6
Mode
3
6
TEMPERATURE SETTING
• These buttons control the temperature
of the room. The temperature can be set within a range of
60°F to 86°F, in increments of 1°F.
MONEY SAVER
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and sample
the room air to determine if more cooling is needed.
OPERATION MODE SELECTOR
• Everytime you push this button, it will rotate between the COOL,
FAN and DRY modes.
ON/OFF TIMER
ON-If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1hr - 2hrs - .....12 hrs
maximum.
OFF - You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the temperature
setting will rise 2°F after 30 min, and once again after another
30min.
• Push Timer button to advance setting from 2 hrs....12 hrs
maximum.
POWER
• To turn the unit ON, push the button. To turn the unit OFF, push
the button again.
• This button takes priority over all other buttons.
• When you first turn it on, the unit is on the High Cool mode and
the temperature is set at 72°F.
FAN SPEED
• Everytime you push this button it will rotate between the
following fan speeds:
High (F3) Low(F1)
6
Medium (F2) High (F3)
• Do not use rechargeable
batteries. Such batteries
differ from standard dry
cells in shape, dimensions,
and performance.
• Remove the batteries from
the remote control if the air
conditioner is not going to
be used for an extended
length of time.