Friedrich CP Line CP08 Manuel D'utilisation Et D'installation page 15

6. The cabinet should be installed with a very slight
tilt (about 1/2") downward toward the outside
(See Fig. 5).
Adjust the bolt and the nut of Sill Support
balancing the cabinet.
7. Attach the cabinet to the window stool by driving
the screws [Type B: Length 16mm (5/8 inch)
and below.] through the front angle into window
stool.
8. Pull each Frame Curtain
sash track, and repeat step 2.
9. Attach each Frame Curtain
sash using screws (Type C). (See Fig. 6)
CAUTION: Do not drill a hole in the bottom pan.
The unit is designed to operate with
approximately 1/2" of water in bottom
of pan.
There is no need to add water if the
pan is dry.
10. Slide the unit into the cabinet. (See Fig. 7)
CAUTION: For security purpose, reinstall the 2
screws (Type A) at cabinet's side, that
were removed in step 1 on page 10.
11. Cut the Foam-Strip
(window width) and insert between the upper
window sash and the lower window sash.
(See Fig. 8)
for
to each window
to the window
to the proper length
Screw(Type B)
6
Screw(Type B)
Sill Support
2
Screw(Type A)
Power cord
13
Sill Support
2
Sash track
Front Angle
6
Fig. 5
Type C
7
Fig. 6
Screw
Fig. 7
(Type A)
Foam-Strip 8
Fig. 8
15