Step 4 Attach Engine To Post; Step 5 Attach Engine/Post To Platform - Endless Summer 233010 Manuel D'utilisation

Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 4 – Attach Engine to Post
Lay Engine Assembly on its side, using large carton for support.
Remove and save Control Knob.
Remove and save Engine Access Panel by removing (1) black
Thumbscrew from bottom of Access Door.
Disconnect wire from Igniter by gently pulling wire from back of box.
Align (4) holes in top of Post with (4) holes in bottom of Engine.
Note: One hole is at a different level than the rest. Make sure that all 4
holes line up properly.
Insert (4) Medium Screws enough to hold Engine in place. They will be
fully tightened at the end of Step 6.
Note: Do not replace Engine Access Panel until Step 11.
Step 5 – Attach Engine/Post to Platform
Insert end of Post without holes over Gas Line, being careful not to bend
Gas Line.
Slide Post into collar of Platform so Post rests completely on Platform.
Tighten bottom three setscrews with hex (Allen) wrench supplied.
Make sure Post is perpendicular to Base.
Use top three setscrews to adjust Post's angle as necessary.
Tighten all six setscrews.
Note: Post must be perpendicular to Base. Failure to do so will adversely
affect burner performance.
Owner's manual: model 233010 outdoor patio heater 6/8/04
®
8