Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 11 – Replace Engine Access Panel
Slide Igniter wire onto Igniter post.
Slide tab at top of Access Panel into slot in Emitter bottom.
Rotate Panel down until holes line up at bottom.
Secure Access Panel in place with thumbscrew.
Replace Control Knob.
Step 12 – Install Igniter Battery
Remove battery cover cap by turning cap counterclockwise.
Install (1) AA battery. Negative end of battery goes in first.
Replace battery cover cap by turning cap clockwise.
Note: Once you have successfully completed assembly steps 1-12 you
are ready to begin operating your heater.
Owner's manual: model 233010 outdoor patio heater
6/8/04
®
12