Maintenance - Omcan Santos 10 Instructions

Maintenance

CLEANING
IMPORTANT:
• Stop the appliance and unplug the power supply cable.
• The appliance should neither be cleaned in a jet of water nor with a high pressure spray.
• The motor unit (7) must not be immersed in water.
You are advised to clean the appliance as soon as it has finished being used.
It will be easier to clean if you do not allow the remaining scraps of food to dry.
1. Remove the cone (2) and rinse it under running water.
2. Rinse the juice container (5) with water, that can be collected in a glass placed on the glass-holder (8).
- Model n°70: Remove the juice container (5) by hand.
3. Finish off cleaning the container with a sponge.
4. Clean the pressing cup (3) with a sponge.
- Model n°70: removing the pressing cup by rotating ¼ turn.
5. Remove the glass-holder (8), the grid (10) and rinse under running water.
6. Model n°10: When more thorough cleaning is required, the pressing cup (3) must be removed. To do this,
unscrew it by turning it anti-clockwise (Fig. B and Fig. C).
The base and the motor unit trim should be cleaned with a soft, damp sponge and then dried.
MAINTENANCE
Prior to carrying out any intervention on the appliance, it must be disconnected from the mains without fail.
Spare parts:
IMPORTANT: Use of spare parts other than certified original Omcan parts is prohibited.
This machine requires no specific maintenance. The bearings are lubricated for life. If any intervention is
necessary to replace parts subject to wear, such as the cone, the pressing cup electrical or other components,
please refer to the parts lists (see the exploded view at the end of this manual).
For all spare part orders (see references in the exploded view at the end of the manual), state:
• The type.
• The machine serial number.
• The electrical specifications recorded under the machine.
8