EdilKamin MYA Installation, Usage Et Maintenance page 34

he rst time you use the product, or should the tank be completely emptied of pellets, to ll the coclea press both keys " "
and " " on the remote control at the same time, holding for a few seconds. As you release the keys, the display should show the
wording "LOAD". his should be carried out before ignition if the stove has stopped due to having run out of pellets, at the end of
operation to empty the combustion pot before turning.
It is quite normal for some pellets to remain, that the cochlea cannot suction.
With the stove on stand-by, press and hold the key
ignition procedure, showing the wording "S AR ". At the same time, a countdown in seconds begins (from 1020 to 0).
Ignition is not at a preset time, however: its duration is automatically shortened if the board reports that certain tests have
been passed. he ame appears after about 5 minutes.
emperatures of below
resistance be temporarily out of action, Diavolina® type re-starters can be used.
Insert a piece of lit Diavolina into the combustion chamber, close the door and press
With the stove working, press the key "M" on the remote control once. he display will show the word " OWER ".
(specifying the power at which the insert is working). ress the keys " " or " " to increase or decrease the insert s
working power (from " OWER 1" to " OWER 5").
ress key "A" to switch to automatic operation, adjusting the temperature desired for the room (use the " " and " " keys
to set the temperature from 5
If a temperature below that of the room is set, the insert will stay on " OWER 1".
With the stove running, press and hold the key
showing a countdown on the display from 9 to 0 (for a total of 10 minutes).
he turn-off phase involves:
Interruption of pellet supply
Ma imum ventilation.
Smoke e pulsion motor.
OPERATIONS THAT CAN ONLY BE CARRIED OUT BY REMOTE CONTROL
ress and hold the key "M" for 2 seconds to access the " lock" menu. his allows you to set the internal electronic board
clock. By then pressing the key "M", the following data appears in sequence and can be regulated:
day, month, year, hour, minutes, day of the week.
he wording "SA E " will appear for con rmation with "M". his will allow you to check that the operations performed are
correct, prior to completion (the wording "SA E" will then be shown on the display).
INSTRUCTIONS FOR USE
, on the remote control for 2 seconds. his will start-up the
will not allow the electrical resistance to heat suf ciently. In this case, or should the
to 5 , and the stove will regulate working power required to reach the temperature set.
rom the remote control for 2 seconds. he turn-off procedure will begin,
the remote control.
- 34
-