Honeywell Home T6 Pro Z-Wave Guide D'installation Professionnelle page 8

Mounting thermostat
1 Push excess wire back into the wall
opening.
2 Close the UWP door. It should remain
closed without bulging.
3 Align the UWP with the thermostat, and
push gently until the thermostat snaps in
place.
4 If needed, gently pull to remove the
thermostat from the UWP.
5 Turn the power on at the breaker box or
switch.
Initial installer setup
• After the T6 Pro Z-Wave thermostat has
powered up, touch START SETUP on the
thermostat.
• Touch or to toggle between Installer
Set Up (ISU) options.
• Touch Edit or touch text area, and then
touch or to edit default setup
option.
• Touch Done or touch text area to confirm
the setting or press Cancel.
• Touch or to continue to setup
another ISU option.
• To finish setup and save your settings,
scroll to the Finish screen at the end of
the ISU list.
NOTES:
• To see a list of all setup parameters, go to
"Installer setup options (ISU) – advanced
menu" on page 15. The thermostat
displays the ISU name and the ISU
number.
• To prevent abnormal operation, it is
highly recommended to perform installer
setup and set thermostat to correct
HVAC system before including it in a
Z-Wave network.
ISU option and
name (scrolling)
ISU option blinking
Saves selected ISU
option moves on to
the next ISU screen
8
View ISU
Arrow buttons
used to scroll
through ISUs
Edit
Edit ISU
ISU #
Arrow buttons
used to scroll
through ISU
options
Done Cancel
Cancels
ISU option
selection, go
back to view
ISU