General Information; Ec Declaration Of Conformity - Atlas Copco GTG40 S060 Consignes D'utilisation Et De Sécurité

page de 132

/ 132
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

GTG40 S060

Personal protective equipment shall be used: Always

wear eye and hearing protection and when necessary

also other personal safety equipment such as gloves,

apron and helmet.

Remember that there is a running on after the

throttle has been released.

If a grinder fitted with an abrasive wheel is

dropped, the wheel must be thoroughly examined

before reuse.

Disconnect from power supply before changing

wheel or servicing.

Release control device in case of interruption of

energy supply.

Always keep the tool in a dry and clean place

when not in use.

Avoid long term harmful effects when

using the machine

Prevent gradual loss of hearing due to exposure

to high noise levels – wear ear protection.

Vibration may be harmful to hands and arms

– Reduce time of exposure to vibration. Poorly bal-

anced wheels should not be used. Use vibration

damped tools when available.

Inhalation of oil mist may be harmful, use only

recommended lubricants.

Dust and fumes generated during operation may

be harmful.

Use spot suction or breathing apparatus. See also

EN 626.

Maintenance

Follow instructions for lubrication, cleaning and

overhaul given in the written instructions supplied

with the machine.

Make sure that service personnel are trained.

Safety and operating instructions

Take special care concerning dismantling and as-

sembly of speed governors and overspend shut off

devices.

Always check the free speed after service.

Use genuine Atlas Copco replacement kits and

parts only.

Warning

Make sure you are familiar with the operating instruc-

tions before you use this machine.

This machine, its attachments and accessories must

only be used for the purpose for which they were

designed.

For product liability and safety reasons any

modification to the machine, its attachments or ac-

cessories must be agreed in advance with an author-

ized technical representative of the manufacturer.

To prevent personal injury and long time risks:

• Familiarise yourself with the enclosed leaflet

"General Safety Manual for Grinders".

• Before making any adjustments to the machine,

e.g. changing an accessory, please ensure that the

air supply is disconnected and the machine is

safely isolated.

• Inspect the wheel guard and before attaching the

grinding equipment.

Always make sure that you have the correct guard

for the grinding equipment.

• Regularly adjust guard to compensate for wheel

wear.

• The grinding equipment must be approved for the

rated speed of the machine.

• Check the free speed of the machine at regular

intervals and whenever the machine has been

serviced. This check should be carried out with

the grinding equipment detached.

NOTE - Before checking the speed the backing

flange is to be locked with the nut.

• The rated speed marked at the top of the machine

must not be exeeded more than 10 %. Adjustment

of the speed is to be carried out according to the

service manual by authorized service personnel

only.