Brandt AD549XE1 Guide D'utilisation page 14

99635141_ML_A_.qxd 22/02/05
C
leaning your hood ?
The power supply to the hood must be turned off either by removing the plug or
by using the circuit breaker switch before you remove the metal filters. After
cleaning, the metal filters must be refitted in conformity with the instructions.
MAINTENANCE
WHY?
HOW ?
Never use metal scouring pads, abrasive products or excessively stiff brushes.
To clean the body and the lighting port, you should use only commercial household cleaning products
diluted in water and then rinse using clean water, drying with a soft cloth.
Dismantling the filter cartridge
Assembling the carbon filter
1. Remove the cartridges.
2. Place the carbon filter on the cartridge, on the inner side of the hood.
3. Fit the 2 fastener clips.
4. Repeat this operation on all of the cartridges.
10:44 Page 14
FILTER CARTRIDGE
Remove the protective film before using the
filter cartridge for the first time.
VITAL EVERY MONTH
This filter traps fatty vapours and dust. This
component plays an important part in
ensuring the effectiveness of your hood.
Use a commercial household cleaning product then
rinse abundantly and dry. This cleaning can be
carried out in your dishwasher in the vertical posi-
tion (ensure that the cartridge never comes
into contact with dirty crockery or silver
tableware).
(fig. 10)
(fig. 12)
ACTIVATED CARBON FILTER
For hoods
"recycling" mode.
VITAL EVERY YEAR
To avoid all risks of fire.
This filter traps odours and must be
changed at least once a year
depending on your level of use.
You should order these filters from
your dealer (quoting the reference
shown on the ID plate located
inside the hood) and note the date
the filter was changed.
installed in