Montage Option Multiair - RIKA DOMO PGI MULTIAIR Notice De Montage

Montage Option MULTIAIR

Cut out the rear wall of the green marks.
Remove the retaining plate of the flame sensor by loosening the two
fastening screws. You can simply pull the flame sensor straight out.
The heat protection plate must be removed before assembly.
Loosen the marked screws from the stove and remove the heat
protection plate. The heat protection plate is no longer needed
after disassembly and can be disposed of. Remove the blind screw
positioned underneath. It is used to fasten the support plate.
Mount the support plate with 3 screws to the stove.
Mount the flame sensor.
Mount the convection fan using 3 long hex bolts.
# 8
Mount the convection fan using 3 long hex bolts.
# 8
Fasten the cable on the fan housing using the cable tie.
# 8
#8
#8
#10