Installation And Connection; Installation Illustration - Norsup 7026965 Manuel D'installation Et D'instructions

3. INSTALLATION AND CONNECTION

3. INSTALLATION AND CONNECTION

3.1 Installation illustration

Valve
Chlorinator cell
Water outlet
Water supply
Pool
Water inlet Sand filter Water pump
(or other type filter)
Installation items:
The factory only provides the main unit and the water unit; the other items in the illustration are
necessary spare parts for the water system, that provided by users or the installer.
Attention:
Please follow these steps when using for the first time
1.Open valve and charge water.
2.Make sure that the pump and the water-in pipe have been filled with water.
3.Close the valve and start the unit.
ATTN: It is necessary that the water-in pipe is higher than the pool surface.
The schematic diagram is for reference only. Please check the water inlet/outlet label on the heat
pump while plumbing installation.
The controller is mounted on the wall