Wagan Tech Smart AC 150 USB Guide D'utilisation page 5

TrOUBLeShOOTInG
Problem: AC product does not operate, green light does not light
Probable Cause
AC product connected is rated at
more than 150 watts; overload
shutdown occurs.
High starting surge has caused
overload shutdown even though AC
product connected is rated at less
than 450 watts.
Lighter socket or 12 volt outlet may
require ignition to be switched on.
Poor contact with lighter socket or 12
volt outlet.
Battery is discharged.
Fuse blown by heavy load.
Problem: Buzzing sound in audio systems
Inexpensive stereo systems have an inadequate internal power supply filtering
which causes a buzzing sound. A system with a high quality filter is the only
solution.
For additional technical support please e-mail customerservice@wagan.com
Wagan and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Please read before using this equipment
©2009 Wagan Corporation. All Rights Reserved.
Suggested Remedy
Use product with a power rating of
less than 150 watts.
Product exceeds inverter's surge
capability. Use a product with
starting surge power of less than
450 watts.
Turn ignition key to accessory
position.
Press inverter firmly into the lighter
socket. Make sure the socket is
clean.
Recharge battery.
Replace the 20A slow blow fuse by
unscrewing the fitting in the positive
connector.