Vbus ® / Data Communication; Lan Connection; Indication And Operating Element; Operating Control Led - Resol KM1 Manuel

Power supply is carried out via an external mains adapter (terminals  and ). The
supply voltage of the mains adapter must be 100 ... 240 V~ (50 ... 60 Hz).
The KM1 Communication module comes with the mains adapter and the VBus
ble pre-connected.
3.3 VBus / Data communication
®
The KM1 Communication module is connected to the controller via the pre-con-
nected VBus ® cable. The corresponding terminal allocation is described in the con-
troller manual.
The VBus can be extended using the terminal block included and a common two-
®
wire cable (twisted).
Connection terminals of the
KM1 Communication module
The VBus cable is pre-connected to the KM1 terminals  and . A further module
®
such as a SD3, GA3, EM1 or AM1 can be connected to the terminals  and .

3.4 LAN connection

The KM1 Communication module can be connected to a router by using a network
cable (CAT5e, RJ45).
Î Connect the network cable included to the network adapter of the router and
to the LAN connector of the KM1.
For the next step of commissioning, see chapter 8 Basic configuration on page 26.
22
ca-
®
The integrated LAN connector is located on the right-hand side of the device. The
LAN connector supports transfer rates of up to 100 MBit per second.
4

Indication and operating element

The following elements are featured on / in the housing of the KM1 Communication
module:
1 operating control LED / reset button
2 LAN connector

4.1 Operating control LED

Operating control LED
The operating control LED indicates the operating status of the KM1 Communica-
tion module by issuing flashing signals and colours.

