Setting The Blade Depth - SIZZIX eclips 2 Guide De L'utilisateur

SET UP
4
SET UP
CONNECTING
1. Plug Power Cord into Universal Power Supply.
2. Plug Universal Power Supply into side of eclips
3. See Bluetooth Instructions or for USB connection:
®
1. Plug USB cable into back of eclips2 Machine.
2. Plug flat end of USB cable into USB port of computer.

SETTING THE BLADE DEPTH

NOTICE
DO NOT adjust blade depth while Machine is operating.
Depth Selection
Arrow
Computer USB Port
Printed on a ring around the Blade Holder Top are Blade Depth Settings, ranging from 1
to 6. These numbers can be selected individually by setting the Depth Selection Arrow on the
number relative to the material you will be cutting.
As a general rule, thinner materials, such as cotton fabric, paper and vinyl, require
a lower number Blade Depth Setting, while thicker materials, such as fabric with iron-
on backing, light chipboard and heavy cardstock, require a higher number Blade Depth
Setting. For optimal results, try a test cut and make the necessary adjustments to the settings
before performing the final cut.
Lower Number for Thinner Material
Higher Number for Thicker Material
2 Machine.
®
Right Side of Machine