Manufacturers Limited Warranty - Jet-tech F-14 Mode D'emploi

MANUFACTURERS LIMITED WARRANTY

Jet-Tech Systems Corporation (Jet-Tech) hereby warrants all new warewashers bearing the name "JET-TECH" and
installed within the United States of America, Canada, the European Community, and the UK to be free from defects in
material and workmanship, under normal and regular usage and operation, for a period of one (1) year for parts and labor.
Labor shall be paid to replace any part found to be defective within this same period.
NOTE: Original warranty for Model F-14 is for one (1) year for parts and ninety (90) days for labor following the date of the
original installation
If a defect in material(s) or workmanship is detected; or found to exist within the stated period above, Jet-Tech, at its sole
discretion, shall either repair or replace any original equipment manufacturers part which has proven to fail within the
machine; providing that the equipment has not been altered or tampered with in any manner, has been installed correctly
as per the owners manual, and maintained and operated in complete accordance with this manual.
The labor cost to repair or replace any part proven to be defective, as per above clause(s), shall be covered by Jet-Tech;
provided that: the service work was performed by an authorized Jet-Tech service agency; and that this agency installed an
original and genuine Jet-Tech part in the machine. Any repair work performed by a non-authorized service depot remains
the sole responsibility of the user, and Jet-Tech will not be held responsible. The installation of any generic part will not
be valid; and therefore voids this warranty. All authorized labor coverage shall be limited to regular hourly rates only.
Any supplemental hourly rates or charges, such as weekends or emergency premiums remain the responsibility of the
user.
Exceptions to above warranty are: (A) Damages resulting from shipping, handling or abuse. (B) Incorrect installation
and/or connections. (C) Adjustments or calibration of any parts. (D) Faults due to lack of regular maintenance or cleaning of
any internal part(s). (E) Replacement of any wearable items such as: peristaltic squeeze tubing or gaskets. (F) Excessive
o
lime, mineral, alkali or hard water conditions (in excess 1,6-3,2 mmol/l = 160-320 PPM = 9-18 dH), and (G) Poor results
due to: use of an incorrect type of detergent (for non-commercial type applications), and excessive or inadequate water
temperature(s) or pressure conditions or incorrect use.
JET-TECH STATES THAT THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, THAT ARE NOT SET
FORTH HEREIN. JET-TECH SHALL ASSUME NO OTHER RESPONSIBILITY, EITHER DIRECT OR NON-DIRECT, OR
BE LIABLE FOR ANY OTHER OR ADDITIONAL LOSS OR DAMAGE WHETHER BEING DIRECT OR
CONSEQUENTIAL, AS A RESULT OF ITS EQUIPMENT.
The manufacturer reserves the rights to alter design and specifications without notice.
7