Scheduled Maintenance - Jet-tech F-14 Mode D'emploi

SCHEDULED MAINTENANCE

DAILY, at day end or when the wash water becomes soiled:
Turn OFF the power as explained on page 12.
Wipe down the outside of the washer.
Remove the rack.
Drain the machine as explained on page 12.
Remove top (F-18DP only) and bottom wash-arms by unscrewing center
hold-down knob, pull wash-arm straight out.
Remove scrap screens and rinse off particles in the sink. Clean the screens
with a brush (Nylon bristles) and mild detergent solution. DO NOT used steel
wool. Rinse the scrap screens.
Clean all food particles in the wash tank. DO NOT flush them down the drain
of the wash tank as this can block the drain pump (F-18DP).
Wipe clean the interior of the wash tank wsith a damp cloth.
Replace and secure all parts that were removed to their original position and close the door.
Leave the power OFF if not using the washer.
WEEKLY:
Clean wash-arms.
Remove top (F-18DP only) & bottom wash-arms by unscrewing center hold-down knob. Remove
end-caps and run water through center hub. Make sure all jets are free of any debris. Replace in
dishwasher. Top and bottom wash-arms can be interchanged (F-18DP).
Visual Inspection.
Open Bottom panel (as shown on page 10). Visually inspect the chemical pumps for cracked
tubes or leaks.
Treat for mineral accumulation.
If your washer has mineral (calcium) accumulation (you will
notice a white-colored film inside the unit), it must be treated
with a de-scaler. Please contact us for more details.
ANNUALLY
Replace all tubes in the chemical pumps.
Verify bushings in wash-arms for excessive wear.
Inspect for leaks and missing or damaged parts.
13