Remote Control Instructions/Pairing - Char-Broil VERTICAL 725 Guide Des Produits

Control Panel Operating Instructions (Continued)
i) Once the desired set time has elapsed:
The controller will automatically reduce the appliance
Ÿ
temperature to 120°F (49°C).
The display will alternate between 00:00 and 120°F
Ÿ
(49°C) showing the set time has elapsed.
An audible beep will sound 3 beeps and then 3
Ÿ
beeps once every 30 seconds thereafter until the
Power Button is pressed, or has reached the
maximum 19 hour automatic shut-off.
4) Meat Probe Button
Display Range: 25°F to 225°F (-3.9°C to107°C)
NOTE: The Set Time function will be disabled.
a) Press the Meat Probe Button, and the default desired
meat probe temperature setting of 145°F (63°C) is
displayed and will blink.
b) Press the "UP" or "DOWN" button to raise or lower the
desired meat probe temperature setting.
c) Press the Meat Probe Button again after the desired
meat probe temperature setting is entered.
d) After the Meat Probe Button is pressed the display
should no longer blink indicating that it is set.
e) When using the Meat Probe function, the display
should show the Chamber Temperature and the actual
Meat Probe Temperature. The display will alternate
throughout the length of the cooking cycle.
f) Once the desired meat probe temperature has been
reached:
The controller will automatically reduce the set temp
Ÿ
to 120°F (49°C).
The display will alternate between the actual Meat
Ÿ
Probe temperature and 120°F (49°C).
An audible beep will sound 3 beeps and then 3
Ÿ
beeps once every 30 seconds thereafter until the
Power Button is pressed, or has reached the
maximum 19 hour automatic shut-off.
5) The meat probe may be unplugged or removed from the food
at any time. If the meat probe is not plugged in or does
not reach the desired meat probe temperature setting,
power to the heating element continues until the Power
Button is pressed, or has reached the maximum 19 hour
automatic shut-off.
6) Optional LED Light Button: This button turns on and off the
chamber light, if equipped.
7) Optional Remote Control: If equipped with a remote control,
please see "Remote Control Operation".
Remote Control Battery Requirements
Batteries Required: 2 each - AAA alkaline batteries. (IEC - LR03,
ANSI - 24A 1.5V DC)
Tips for proper battery care and use
Use the correct size and type of battery specified.
Ÿ
Avoid mixed use of batteries, i.e. new, used or different types of
Ÿ
batteries.
Keep battery contact surfaces and battery compartment
Ÿ
contacts clean.
Remove batteries from the remote control when it is not
Ÿ
expected to be in use for several months.
Make sure that you insert batteries into the remote control
Ÿ
properly, with the + (plus) and – (minus) terminals aligned
correctly.
Rechargeable batteries are not recommended.
Ÿ
Keep batteries out of reach of small children. Should a child
Ÿ
swallow a battery, consult a physician immediately.
Always remove exhausted batteries from the remote control and
Ÿ
dispose of properly.
7