Setting The Time For Dimmer; Changing The Display Color - JVC KD-AR880 Manuel D'instructions

Category Indication
Amp Gain
Amplifier gain
control
Color Sel
Color selection
Color Set
Color setting
Red
Green
Blue
*
9 Only for KD-AR880.
*
10 Depends on the "Dimmer" setting.

Setting the time for dimmer

• When appears on the display, you can move
back to the previous display by pressing number
button 3.
1
Follow steps 1 to 3 on page 31.
• In step 2, select "DISPLAY."
• In step 3, select "Dimmer."
2
Select "Time Set."
34
Item Setting, [reference page]
( : Initial)
• High PWR : Volume 00 – Volume 50
• Low PWR : Volume 00 – Volume 30 (Select if the maximum power of
each speaker is less than 50 W to prevent damaging the
speaker.)
• Off * 9 : Deactivates the built-in amplifier.
Initial: All : Select your favorite display color for each source (or for all
Source sources), [34].
— : Create your own colors, and select them for the display
color, [35].
: User color during the day time *
Day Color
: User color during the night time *
NightColor
00 – 11 : Initial: Day Color: +07, NightColor: +05
00 – 11 : Initial: Day Color: +07, NightColor: +05
00 – 11 : Initial: Day Color: +07, NightColor: +05
3
4

Changing the display color

You can select your favorite display color for each source
(or all sources).
• When
Setting the display color
1
10
10
Adjust the dimmer time.
1
Turn the control dial to set the dimmer time.
¢
2
Press to select "To." Then, turn the
control dial to set the dimmer end time.
Exit from the setting.
appears on the display, you can move
back to the previous display by pressing number
button 3.
Follow steps 1 to 3 on page 31.
• In step 2, select "COLOR."
• In step 3, select "Color Sel."
.
.