Speed Change - Makita DF012D Manuel D'instruction

Lock lever
CAUTION:
When not operating the tool,
always set the lock lever in the locked position B.
1
► 1 . Lock lever
When the lock lever is in the locked position B, the
switch cannot be actuated.
When the lock lever is in the unlocked position A, the
switch can be actuated.
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch actuates properly and returns to the "OFF"
position when released.
CAUTION:
Always check the direction of
rotation before operation.
A
► 1 . Lock lever 2. Switch
To start the tool, first move the lock lever to the
unlocked position A to release the switch. And then sim-
ply push the switch on the
rotation and the D side for the counterclockwise
rotation. Release the switch to stop.
NOTICE:
Change the direction only after the tool
comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the tool.
A
B
B
1
C
D D D D D D D D D D D D D D D D D
C side for the clockwise

Speed change

1
► 1 . Speed change lever
CAUTION:
fully to the correct position. If you operate the
tool with the speed change lever positioned halfway
between the "1" side and "2" side, the tool may be
damaged.
CAUTION:
while the tool is running. The tool may be damaged.
Position of
speed
change lever
1
2
To change the speed, switch off the tool first. Select
the "2" side for high speed or "1" for low speed but high
torque. Be sure that the speed change lever is set to the
correct position before operation.
If the tool speed is coming down extremely during the
operation with "2", slide the lever to the "1" and restart
the operation.
2
5 ENGLISH
Always set the speed change lever
Do not use the speed change lever
Speed Torque
Low High
High Low
Applicable
operation
Heavy load-
ing operation
Light loading
operation