SOUNDMASTER DISC5000 Mode D'emploi page 23

SETT ETTING THE CLOCK TIME (REMOTE CONTROL ONLY)
In this example, the clock is set for the 24-hour (0:00) display.
1. Press the STAND-BY/ON button to turn the power off.
2. Press the CLOCK button 2 seconds.
3. Press the" "or" "button to select 24-hour or 12-hour display and then press the CLOCK button.
The 24-hour display will appear.(0:00 - 23:59)
The 12-hour display will appear.(AM 12:00 - PM 11:59)
The 12-hour display will appear.(AM 0:00 - PM 11:59)
4. To adjust the hour, press the" "or" "button and then press the CLOCK button. Press the" "or" "button
once to advance the time by 1 hour. Hold it down to advance continuously.
5. To adjust the minutes, press the" "or" "button and then press the CLOCK button. Press
the" "or" "button once to advance the time by 1 minute. Hold it down to advance.
NOTE:
When power supply is restored after unit is plugged in again or after a power failure, time display will be
blinking. Reset the clock.
To readjust the clock:
Perform "Setting the clock Time "from step.
Timer operation (Remote control only)
Timer playback:
In this example, the clock is set for the 24-hour (0:00) display.
1. Press the TIMER Button once to turn the TIME function on. The TIME indicator " " will appear in the
DISPLAY.
2. Press the TIMER button 2 seconds, the display will show "ON" The display will show" "to indicate timer
function on and the "hour" digit of the timer clock will flash.
3. Press the" "or" "button to adjust the hours for timer on and then press the Time button.
4. Press the " "or" "button to adjust the minutes ours for timer on and then press the time button.
5. Press the" "or" "button to adjust the timer off (as in step 3 and 4) and then press the time button
6. To select the timer playback source (TU, CD, USB), press " "or" " button. Press the TIMER button.
7. Adjust the volume using the VOLUME (+ or -) on the main unit or VOL +/- on the remote control, and then
press the TIMER button. Do not turn the volume up too high.
8. The" " indicator lights up and the unit is ready for timer playback.
Sleep operation (Remote control only)
This function allows you to program the system to switch off itself after a set period of time. You can set your
sleep time in power on mode:
1. To activate the sleep function, press the SLEEP button on the remote, the display will show "Sleep Timer-
OFF,90,80,70,60,50,40,30,20,10" and flash.
2. When the display shows your desired sleep time, release the button, the sleep timer is now activated. The
display will show "SL10" indicating "10 minutes" sleep time and so on. When the sleep time counts to zero,
the unit will go off.
3. To cancel sleep, press the SLEEP button once again, the sleep function will turn off.
E-8