Weighing; Check-Weighing - Adam WBW Serie Manuel D'instructions

EN
2.4

WEIGHING

To determine the weight of a sample, first tare an empty container if used, then place the sample in the container.
The display will show the weight and the unit of weight currently in use. To change the weighing unit press the [Unit]
key.
2.5

CHECK-WEIGHING

Check-weighing is a procedure to show a display or sound an alarm when the weight on the platform meets or
exceeds the values stored in the memory. The memory holds values for a high limit and a low limit. Either or both
the limits can be set by the user.
The LCD display will indicate whenever the weight is within or exceeds the limits by showing
"HI"
the limits), (mass is above the high limit) or
The limits can be locked by the manager (see the menu structure section) .A Limit Password must be used to change
the limits or recall other limits from memory.
Setting up the limits
In normal weighing, Press the [Limit] key. It will show the current high limit.The user will be asked for the password
if the current check-weighing password is anything other than "0000". See the parameter
Enter the correct password using the numeric entry method as mentioned in section 2.1. If the password is "0000"
it will display the last used high limit. The
Press [Tare] to accept the displayed high limit or enter the new high limit using the numeric entry method (see section
2.1). When the desired value is entered press [Tare] to accept the value. The
show the last used low limit. Set the low limit in the same way the high limit was set.
Pressing the [Tare] key will return the scale to weighing, with the Check-weighing function enabled.
NOTE: The limits are displayed in the weighing unit in use. The decimal point is fixed at the position that is used for
the current weighing unit. If the weighing unit is pounds:ounces, the limits are entered in pounds and decimal parts
of pounds. i.e. 6.0125 lb.
Limits stored in memory
If the scale is turned off, it stores the last high and low limits in the memory along with information about the
weighing unit in use when the limits were stored. If the scale is turned on again, the limits and the weighing
unit will still be active.
© Adam Equipment Company 2014
"LO"
( mass is below the low limit).
"HI"
symbol will appear on the display.
3
"OK"
"F4 PS"
"LO"
symbol will be on. Display will
3036610540RevB-Nov14
(mass is between
in menu structure.