Setting Up And Turning On The Scales; Operation; Numeric Entry Method; Zeroing - Adam WBW Serie Manuel D'instructions

EN
1.0

SETTING UP AND TURNING ON THE SCALES

There are three series within the range: WBW-M, WBW and WBWa. The WBW-M scales are configured at the factory
for compliance with EN 45501, OIML R-76. They have different capacities and readabilities from the standard WBW
series. The WBW series are similar to the WBWa series except the WBW scales are usually set for metric units,
whereas for the WBWa series are usually set for imperial units.
SETTING UP
The WBW Series comes with a stainless steel pan. Place it on the top if already not installed. Do not press with
excessive force as this could damage the load cell inside.
Level the scale by adjusting the four feet. The scale should be adjusted such that the bubble in the spirit level is in
the centre of the level and the scale is supported by all four feet. Attach the power supply module to the bottom of
the scale and plug into the mains. Press the [O/I] key to start. The software revision number will be displayed
followed by a self-test showing all digits before the zero is displayed along with the unit of weight that was selected
last.
NOTE: the scale can be operated from the battery. If desired, the battery life is approximately 50 hours. When the
battery needs charging a symbol on the display will turn on. The battery should be charged for 12 hours for full
capacity.
2.0

OPERATION

2.1

NUMERIC ENTRY METHOD

To set a value when required, use the keys as given below-
- [Limit] key to increase the flashing digit
- [Unit] key to move to the next digit and
- [Tare] key to accept the value
2.2

ZEROING

You can press the [Zero] key at any time to set the zero point from which all other weighing and counting is measured.
2.3

TARING

Zero the scale by pressing [Zero]. The zero indicator will be on. Place a container on the pan.
Press [Tare] when the reading is stable. The weight that was displayed is stored as the tare value, leaving zero on
the display. The stable and
As a sample is added only the weight of the product will be shown. The scale could be tared a second time if another
type of product was added to the first one.
Press [Tare] or [Zero] to remove the tare value and display zero. The
© Adam Equipment Company 2014
The scales have an automatic re-zeroing function to account for
minor drifting or accumulation of material on a connected
platform. However you may need to press [Zero] to re-zero the
scale if small amount of weight is still shown when the platform is
empty.
Net
indicator will be on.
2
Net
indicator will disappear.
3036610540RevB-Nov14