Positioning Racks And Bakeware; Oven Vent; Baking And Roasting - Amana AER6603SFS Instructions D'utilisation

Positioning Racks and Bakeware

IMPORTANT: To avoid permanent damage to the porcelain
finish, do not place food or bakeware directly on the oven door
or bottom.
Bakeware
To cook food evenly, hot air must be able to circulate. Allow
2" (5 cm) of space around bakeware and oven walls. Make sure
that no bakeware piece is directly over another.
Racks
Position racks before turning on the oven.
■
Do not position racks with bakeware on them.
■
Make sure racks are level.
■
To move a rack, pull it out to the stop position, raise the front
edge, and then lift out. Use the following illustration as a guide.
5
4
3
2
1
Rack Positions
Rack 5: Toasting bread or broiling thin, non-fatty foods.
Rack 4: 2-rack baking and broiling.
Rack 3: Most baked goods on a cookie sheet, muffin pan, or jelly
roll pan; and layer cakes; broiling chicken pieces.
Rack 2: Pies, casseroles, yeast bread, quick breads, frozen
convenience foods, and 2-rack baking.
Rack 1: Roasting large and small cuts of meat and poultry.
Multiple Rack Cooking
2-rack: Use rack positions 2 and 4.
Baking Layer Cakes on 2 Racks
For best results when baking cakes on 2 racks, place flat racks in
positions 2 and 4. Place the cakes on the racks as shown.
Baking Cookies on 2 Racks
For best results when baking cookies on 2 racks, place flat racks
in positions 2 and 4.
10

Oven Vent

A
A. Oven vent (ceramic glass model)
The oven vent releases hot air and moisture from the oven
and should not be blocked or covered. Blocking or covering the
oven vent will cause poor air circulation, affecting cooking and
cleaning results. Do not set plastics, paper, or other items that
could melt or burn near the oven vent.
On coil element models, the element can be used when the oven
is in use as long as the cookware does not extend more than 1/2"
(1.3 cm) over the element.

Baking and Roasting

NOTE: The convection fan will shut off when the oven door is
opened. If the oven door remains open for too long, the heating
elements will shut off until the oven door is closed. All timers,
including any active Cook Time or Timed Cook functions, will
continue to count down.
Oven Temperature
While in use, the oven elements will cycle on and off as needed
to maintain a consistent temperature, but they may run slightly
hot or cool at any point in time due to this cycling. Opening the
oven door while in use will release the hot air and cool the oven
which could impact the cooking time and performance. It is
recommended to use the oven light to monitor cooking progress.
NOTE: On models with convection, the convection fan may run in
the non-convection Bake mode to improve oven performance.
Temperature Management System
The Temperature Management System electronically regulates the
oven heat levels during preheat and Bake to maintain a precise
temperature range for optimal cooking results. The bake and broil
elements or burners cycle on and off in intervals. On convection
range models, the fan will run while preheating and may be cycled
on and off for short intervals during Bake to provide the best
results. This feature is automatically activated when the oven is in
use.
Before baking and roasting, position racks according to the
"Positioning Racks and Bakeware" section. When roasting, it is
not necessary to wait for the oven preheat cycle to end before
putting food in unless it is recommended in the recipe.
Preheating
When START is pressed, the oven will begin preheating. Once
100ºF (38ºC) is reached, the display temperature will increase as
the actual temperature of the oven increases. When the preheat
temperature is reached, a tone will sound and the selected
temperature will appear on the display.
A
A. Oven vent (coil element model)